Masonry Bits
What Are Masonry Drills Bits?
Masonry drill bits are similar to twist drill bits but are instead made from softer steel. A tungsten carbide is brazed into the section to form cutting edges.
Brick drill bits are often used in conjunction with a hammer drill. This pushes the drill bit into the material as it spins. There are moving spirals on the drill bit that keep dust away. As the drill rotates, the cutting edges move towards the bottom of the hole.
A special shank shape similar to the SDS type is usually used in hammer drill bits. The bit can slide in the chuck when hammering is taking place instead of the chuck acting as the hammer.
The diameters of masonry drill bits vary between 3mm and 40mm. The largest holes will need drill bits of 1000mm with hand-portable power tools. These are frequently used when dealing with plumbing and wiring in buildings.
Should I Get a Single Masonry Drill Bit or Set of Masonry Drill Bits?
Deciding between single masonry drill bits or an entire set of masonry bits is dependent on how much drilling you expect to be doing. If you only intend to do a few odd jobs then some single drill bits are more than sufficient. 1/4 and 5/16 sized drill bits are likely your best option as they are the most commonly used. They allow you to perform many different types of jobs and are suitable for a wide variety of uses.
If, however, you intend to do a lot of jobs around the house, then acquiring a full set of masonry drill bits is the way to go. These drill bit sets will provide you with maximum flexibility and the right tools for the job every time. They allow you to pick the right bit for the right hole size as well as the correct attachment for drilling. There are a lot of choices out there with different sets meeting different needs, so make sure to pick one that suits you.
I Don’t Know What Masonry Drill Bit I Need
It can be difficult to figure out what to do when it comes to drilling holes with masonry drill bits. You’ll need to make the hole size smaller than the concrete screw that’ll be used. For example, a 3/16 screw will need a 5/32 hole and a 1/4 screw needs a 3/16 hole in the material. For sleeve or wedge anchors, you’ll need the same hole size and the size of the anchor.
Alternative to Masonry Drill Bits
Star drill bits are an alternative that is similar to masonry drill bits. They look alike and work in a comparatively similar way, but are used with a hand-powered drill and hammer to drill into stone. The cutting edge of this drill bit has many blades (in the shape of a star) that are joined at the centre.
How to Use a Masonry Bit
Using masonry drill bits can be a little tricky for beginners. Most of them work in a similar way, but there are different types, so make sure to read instruction manuals carefully and ask for assistance if you aren’t sure.
Contact Us
If you have any questions about our stock of masonry drill bits, contact us! We’ll be happy to answer your questions and help you find what you need. Phone: (407) 385-3511.
